Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

Drew P · 01-04-2014, 11:43 AM

Trying to install my intake from CAI. The end of the silicone tube that fits over the MAF housing appears to be far too large. Even tightening the clamp is not enough to seal the tube over the MAF Housing. I have the flanged end of the silicone tube attached to the throttle body as the instructions say. Anyone have this issue during their install?

Edit: Problem was with the clamp. All good now.

Edit: Managed to get clip to force seal the tube (i think), but the oil breather tube touches a pulley unless turned horizontally.

01-04-2014, 11:43 AM	#1
Drew P Drives: Camaro ZL1 Join Date: May 2012 Location: Houston Posts: 233	CAI Silicone Tube Fitment Issue Trying to install my intake from CAI. The end of the silicone tube that fits over the MAF housing appears to be far too large. Even tightening the clamp is not enough to seal the tube over the MAF Housing. I have the flanged end of the silicone tube attached to the throttle body as the instructions say. Anyone have this issue during their install? Edit: Problem was with the clamp. All good now. Edit: Managed to get clip to force seal the tube (i think), but the oil breather tube touches a pulley unless turned horizontally. Attached Images Last edited by Drew P; 01-04-2014 at 10:21 PM.