I bought a set of torx sockets from NAPA. I read a few 'installation guides' and saw both T50 and T45, so I got a 9 piece 3/4" impact wrench set with T25-T55 for $26 bucks! T50 was the right number, and I am sure a single socket would have likely been more reasonable - but I couldn't quibble with a good impact set for so cheap. I already had a torque wrench and a 1/2in to 3/4in stepper, so I was good there (cause, you know, proper torque is pretty important).
The hardest part was releasing the airbag - I just didn't to pull on the airbag enough fearing it would go off in my face.
Quote:
Originally Posted by rgrmoreira13
same here. I have a 1LS and have to the ZL1 steering wheel. that screw in the middle is a pain. I don't have the right tools for it. I had issues with it.
|