I put them in over a year ago and love the look. I recently installed a couple of LED strips in them too (I swapped out the DRL bulbs since these pics to make them more bright and more closely match the LED's). It wasn't that bad taking off the front fascia. Then you take the lower grille out of that and eyeball where the ducts are going, especially the inside angle, measure, eye ball and measure again, then make the cuts in the grille. You put it back into the fascia, reassemble it on the car and then glue/tape in the ducts.
__________________
Traded-in car: K&N Typhoon intake, JBA Shorty headers, Solo mid-pipes/hi-flow cats, GMPP Track Pack axle-back, Vmax ported TB, Billet Custom catch can, billet tensioner pulley, Hines Hex Vents, Z/TA rear spoiler, ProCustom headlight covers, Drake black/riveted quarter window covers, GM satin fuel door, chrome and brushed caps/covers under the hood, EmblemPros underhood bowtie & fuel rail "Camaro" plates, chrome "SS" door kick-panels, chrome trunk latch plate & strut rods, Street Scene lower grille ducts w/LED lights, front bowtie-delete, Yates Performance pedals, 35% tint, etc.
|