Were back to work on Pumpkin installing the Rhino prepared manifold, Vmax PTB, GM heater hose relocation kit an SLP UDP and Rhino tune. Things went fairly well removing the manifold except those stupid little green safety locks on the injectors, man there a pain and the clamps at the heater core are a bit difficult even with the cable driven clamp remover.
All set to put it back together this morning once I stop at Straddle Craft to pick up the freshly painted IOM manifold cover and rear diffuser.
Once the manifold and heater hose relocation kit is done, then it's out with the rad and off with the balancer for the UDP installation. Take note of the back two manifold bolts with the duct tape, you will have to do that on the way and way in with the manifold.
