[lbheat]

Originally Posted by CamaroI

After speaking with Sickness and how his is mounted without rods in going to leave them off. In a nut shell bolting the Apr splitter to all 15-20 bolts underneath holding zl1 grill on. This should give it enough support at least I hope so. I don't plan on drag racing and not a daily driver. Sickness bolted his up this way and states extremely solid. Keeping my fingers crossed


Sent from my iPhone using Tapatalk

I havent counted the amount of bolts but it did have a lot inside the bag. I had a seibon carbon fiber lip on my ss bumper and I put about 10 bolts across the bumper with no tie rods. But then again it was a hard lip that had no flex at at and this one flexes quite a bit. What I might do is put a gopro camera pointing down to lip and see how much it flexes while driving through the wifi feature. If its flexing too much then I'll just pull over and take it off to install rods. I just dont want to put any other part on my car in jeopardy.