I wanted to start a write up on my current hood productions from Eric at MPD1. Not sure what Eric is going to name hood, but wanted to give him a shout out for all the hard work.
Several months ago I contacted Eric about building a hood similar to my current design. I wanted a hood that would provide clearance for a Whiple Supercharger and wouldn't require using a hood liner. The goal was to have a clean finish out underneath as well as incoorperating Hex Vents along with other custom fabrication work.
After many back and forth discussion and recommendation by Eric he agreed to take the project on. Needless to say his work is amazing!! Here is the hood currently in production.
I wanted to also give a shout out to TRC-SS for allowing me to use his original design which is seen on his car and mine currently. Another shout out to Steve at Hex Vents for providing demo Vents used during the building process. This allowed zero downtime with current hood since not having to remove Hex vents for build. Shout out to Showstoppers as well for coordinating with Eric off of Heat Extractor desgin and allow this build to move forward.
With the coordination of all these Members and Vendors Eric has created a masterpiece
Looking forward to posting up final production photos along with painting and installation.
Planning out
