Quote:
Originally Posted by Apex Chase
If you refer to our installation instructions at the link below it will give you a good look at the PCV line connection and how to disconnect it.
Only two corbin clamps are needed. That is an error in our instructions that has not been updated yet. The hoses lock onto the push lock fittings so there is no need for them there. You only need them on the end that attaches to the engine and even there they are over kill.
http://www.apex-speed.com/installation.html |
Thanks for the reply chase, yea thats the instructions im using... unfortunately I cant tell what way the clip is being bent, im sure its simplr but again I dont wanna break it from pulling it the wrong direction