At first I had the Flowmaster axel back, than bought a Mag 11385, which did kill rasp, but with both of them overall just not loud enough.
Than I took off the 11385 and went back to only the Flowmaster axel back (40's)
Than thought it was again to raspy.
So I took off the flowmasters and put back the 11385 only with the factory pipes which include the resonators and end about at the rear axel. Drove it around going thru all the revs like this, and I think this is the sound I'm after but could probably be improved.
So if I use 11385, and get straight pipe installed in place of the factory pipes which have the resonators, I'm wondering how much louder this would be.
Right now with just the 11385 and factory pipes ending at the rear axel (nothing past that point)..it sound great, very retro hot rod sounding. But to get custom piping installed all the way from the 11385 that would be kinda expensive..so I hesitate. THe other alternative would be to just get a shop to install pipes from the ends of my factory pipes to the rear with tips on it.
Lastly, I could install a crack pipe in place of the H pipe, than I'd finally end my mods because I can't afford any of them, and may have to sell the car entirely.
