Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

Ricown · 08-10-2009, 02:29 PM

Ok so I have been reading a lot about the car and the factory B.A. I want to install a Hertz ML3000 here are the tech specs for this speaker.

Size 300mm (12inch)
Comp Subwoofer
Sensitivity 89dB/SPL
Power handling 1500W peak, 750W continuous
Frequency response 25Hz -900Hz
Impedance 4 Ohm

http://www.hertzaudiovideo.com/default_en.htm

I was also looking at getting a Hertz Amp to power this sub the amp that I am looking at is the Hertz EP 2 X 700w amplifier here are the tech specs for the amp.

Channel Model 2-1
Output power
(RMS @ 14.4 VDC, THD 1% 220W x2 (4oms)
700W x1 (4oms)
350W x2 (2oms)
Distortion- THD (100Hz@4oms) 0.05%
S/N Ratio (A weighted @ 1v) 100dB
Dampening Factor (100 Hz@4oms) 130
Size (mm) 240 x450 x54

http://www.hertzaudiovideo.com/default_en.htm

Ok now that is out of the way here is the brass of my question. Is this amp strong enough to push that woofer or do I need to go to a higher rated one? Also will the factory head unit be able to handle this? If it is can some one tell me where I can buy these I have been looking online and have not been able to find a place that sells them. I live in Yuma, AZ is there a sound shop in SD that can do the install on a camaro I don’t really trust any place in Yuma to do it right. all of this would be put into a 2LT thanks for any help.

08-10-2009, 02:29 PM	#1
Ricown Drives: 2010 2LT/RS CGM Join Date: Aug 2009 Location: yuma, AZ Posts: 40	Hertz Audio question. Ok so I have been reading a lot about the car and the factory B.A. I want to install a Hertz ML3000 here are the tech specs for this speaker. Size 300mm (12inch) Comp Subwoofer Sensitivity 89dB/SPL Power handling 1500W peak, 750W continuous Frequency response 25Hz -900Hz Impedance 4 Ohm http://www.hertzaudiovideo.com/default_en.htm I was also looking at getting a Hertz Amp to power this sub the amp that I am looking at is the Hertz EP 2 X 700w amplifier here are the tech specs for the amp. Channel Model 2-1 Output power (RMS @ 14.4 VDC, THD 1% 220W x2 (4oms) 700W x1 (4oms) 350W x2 (2oms) Distortion- THD (100Hz@4oms) 0.05% S/N Ratio (A weighted @ 1v) 100dB Dampening Factor (100 Hz@4oms) 130 Size (mm) 240 x450 x54 http://www.hertzaudiovideo.com/default_en.htm Ok now that is out of the way here is the brass of my question. Is this amp strong enough to push that woofer or do I need to go to a higher rated one? Also will the factory head unit be able to handle this? If it is can some one tell me where I can buy these I have been looking online and have not been able to find a place that sells them. I live in Yuma, AZ is there a sound shop in SD that can do the install on a camaro I don’t really trust any place in Yuma to do it right. all of this would be put into a 2LT thanks for any help.