[97one]

Originally Posted by sgtwilldog

He gave me a warning and didn't give me the $125.00 citation "this time". But he patrols same town I live in "oak harbor" so I can't dodge him very much longer. Here is what it looks like others are doing:

1. hideaway but requires drilling - http://www.swiftmotorsports.com/prod...cda12b7b10d002

2. this one is no drilling but takes some time to remove - http://www.bdspeedshop.com/item.cgi?...sm&part_id=184

I can't decide which to go with...

I would go with the ...................#1.
1. hideaway but requires drilling - http://www.swiftmotorsports.com/prod...cda12b7b10d002

Maybe you could lengthen the bottom piece so you could mount it in THE CENTER of the car. OFF CENTER looks very bad ...IMO
That one slides under which looks nice (in the photo anyway)
Bottom holes won't be seen.
OR ...you could use the orig. mount & mount it in the lower CENTER like on another Tread W/photos...........(w/Zip Ties With no cost to you )......& It did look Good.
OR ...you could mount it in the factory center spot, where it looks very good.
If you are going to sell in a yr. or 2...............the next owner will have to deal with the holes.............But if he is from your state he needs it anyway.

The factory mount does look good, IF like you said you MUST put a plate on !