Quote:
Originally Posted by vatechguy3
for those of you who have tried these, how do they compare width wise to the stock rear guard?
I am still contemplating ordering the stock GM 2013 rear shields:
CHEVROLET GM OEM 22895337 Rear Bumper-Splash Shield
CHEVROLET GM OEM 22895336 Rear Bumper-Splash Shield
this way, the car will maintain the OEM look. I have seen a few threads on here where the guys started with the above GM parts and cut off the recessed section and installed them similar to the ebay versions.
thoughts?
thanks
tony
|
I was going to go that route too, but I couldn't find out how they were attaching them. The stock rears have to be cut up quite a bit to work and it doesn't leave anything for the 2 screws in the fender well to connect to... I am assuming they use nothing but double sided tape.