[KaBoom1701]

Originally Posted by LSX Camaro

I recently finished up installing the vent on my 2010. I made the template from cardboard. With the vent upside down you can place the cut cardboard and see how your cut line will look. There is a decent margin for error. I used a electric cut off die grinder with a 6" wheel. I masked off the hood and fenders with tape, cover the engine and car with blankets. Looking back it would have been better to remove the hood and cut away from the car.

My advice is measure and re-measure then measure again. Only cut once. I went to my local Chevy dealer and measured a new Camaro on the lot to get the placement measurements. It is 16 1/4 from the back of the hood to the edge of the vent. However that is not your cutting line. The center left/right is easy with the line in the hood.
There are 6 mounting studs on the vent, I made my own brackets to secure. With the insulation cut they are all hidden. I did not use the factory under hood water deflector. Defeats the entire purpose of venting out under hood heat. Over all it was an easy install that came out great. Anyone considering this just remember to measure and make sure your template is accurate.

Good. How much will you charge to do mine? lol