update ... install went well and everything works perfect! double checked everything and test fit, then did the final install while checking to make sure they functioned during each step
one of the pics will show where I had to drill a hole and cut out a clearance at each light bucket due to the wiring coming out of the housing not letting the housing slide all the way in (pic of bottom also shown)
technostalgia lights installed:
http://youtu.be/tVcHliY97nc
right side replaced...
clearenced for wiring to exit light bucket...
bottom of housings...
all installed and tucked away...
my little helper screwing in all the nuts...
Typing fat fingered on my GS3...excuse any sfelling mitcakes
__________________
2010 2SS - CAI Intake, ADM Scoop, RotoFab Washer relo. LT Headers and off-road pipes, X-pipe, Muffler Deletes, ZL1 Spoiler, Technostalgia Tail-lights
'98 T/A (Sold) - Forged 6.0ltr, MS3, P&P'd Heads/Valves, 90MM FAST/TB, Headers, 3" Y-pipe, 4" Mufflex Catback. Koni Adjustables w/GC coilovers (550/175), Strano Sway Bars
'94 Z28 (Sold) ... LS1 swap (basically same setup as the T/A), TH350/3500 stall ... swapped it all into the T/A
-- >>
Some of my Projects My Fquick Page