OK, just finished installing the backup camera. Had the existing camera mount from the factory so I didn't have to remove the rear bumper.
Installed and routed the camera wire down the passenger side -- I didn't have to remove the seat -- just the rear passenger panel and trim -- used the existing wire runner.
Installed -- still needed to tighten it down @ this point (that took a while!) but wanted to show how the factory placement was:
Once bolted down, fits right and very tight. Boy, there is a lot of dirt collected in there!
Used Velcro to hold the connector in place:
(Sorry for the fuzzy pic):
Next, the Mylink install...
-Don