OK, got lucky on the passenger's side -- the header only had to be loosened and twisted to the right -- and full access to the bolts!
So, following the same pattern, loosened the head bolts in reverse order, then got it ready to r n r:
Passenger header loosened:
Pulled the passenger side O/2 connector out of the way (next to the starter you'll see the opening where I pulled it from:
Unbolting the passenger head:
Head removed! Again -- NO DexCool all over the place!:
Wash looks good on this side too.
Passenger head -- looks good...:
Protecting until I get to the lifters (next!):
Heads ready to return to GPI:
-Don