[Angrybird 12]

Here is my setup to put it in my car where the hud controls normally go.
I took some 3/16" thick plexiglass and cut it out the size of the control box. I then made a groove it it for the wire to lay in so it will exit on the left side. I then mounted 3 rare earth magnents into the bacside of the plexyglass. I took a piece of sheet metal and cut it out to fit the recess in the dash. I put two sided tape on the plexiglass and mounted the controller on it. And two sided tape on the sheet metal to attach it to the dash. I covered the exposed part with flat black vinyl.
I will have to wait until it warms up some before putting this all in the car.