OK, last thing for the night, installed the ADM CAI:
First, had to remove the AC clip and move the line, and the 'old' snap bolt for the original CAI:
Panel test fit with ac line moved:
Note the intercooler line fits perfect!:
Now, the MAF goes in 1 way -- and it will not fit the other -- note the arrow:
Note how we ran the MAF connector inside the CAI:
Aligning the tubing -- each piece is marked by ADM, just manipulate so it all fits:
Air filter:
Readying the lid:
Now, there are 3 longer bolts -- those go down the side -- just put them in finger tight as you need to 'align' everything...
Now, to put on the lid, you need to remove the water bottle cap:
Slide the lid on, and slowly install the bolts (with washers) just enough until you get all the bolts in. Once in, tighten just enough to 'feel' it won't give anymore (don't over tighten!). Put the water bottle cap back on (it has a 'guide' on the cap so you'll be able to line it up):
Barb is the last item to install -- that will come tomorrow...
More to come!
-Don