[hammdo]

Alignment test:



Then, prep for the holes to be adjusted:



After adjusting the holes to fit the bolts on the spoiler, it was time to drill for the locating clips:





I used a 1/8 drill with a drill stop and then drill out to 5/16 also with a drill stop -- worked like a champ!

Once those were setup and I confirmed fitment, it was now time to cut some electrical tape to cover the holes (to prevent paint chipping) and apply clear silicone to seal for water. I then put the spoiler on -- using the locating clips and then pushed down to ensure the clips snapped in and the bolts cleared. To bolt down, I used my 10 mm magnetic socket and extension

To get to the two middle bolts, I did it this way -- inserting the socket with swivel and once threw the hole, put the nut with the washer on -- then bolted it down:





Bolted down and test fit:









Nice!