[wrp]

Eventually I have decided I have to cut the OEM Console. Didn't want to do it but didn't cut enough to hurt the structural integrity of it. First I mocked up the base cover with cardboard and fitted it so the console trim piece would still snap in. One of th3e difficult things about that trim piece is that they seem to have designed it so nothing else would work with it, lots of curves. I just straightened them out some.





Eventually I even cut the centr trim brace on the trim piece.





Fitment seems pretty good and gear shifter travel seems to be okay. Ther is adequate room to mount the electronics behind the shifter, including the Leash boost control window which I am really considering moving above the Radio or in the hole the radio will leave. I am using aluminum as the base. Haven't decided on the thickness but will probably have it as thick as I can and still snap the consoie trim back in place.



Here are a few shots with the shift levers in different positions.