Quote:
Originally Posted by yotaman96
I just installed my MSD launch controller this afternoon. I used the Lingenfelter Ctap-001 along with their plug and play harness. The plug on the clutch position sensor was a pain to get to. You can't see it, so you just have to feel around for it. Once the breakout harness is plugged in, the purple wire on the Ctap hooks to it. The orange wire on the Ctap hooks to the MSD box. I used the 12V source, so I used the blue and white wire on the MSD box. I have the red wire on the Ctap hooked to a switch with a 12v fused power source going to it. The only other connection needed is the black wire on the Ctap gets hooked to a ground.
|
So you used the LPE Ctap, MSD controller, and the LPE harness?