Quote:
Originally Posted by 1Canuck
So based on positive reviews I installed the VTC 10 days ago and it has been wonderful. Yesterday at some point the CEL lite up. drove home with no other issue and parked the car overnight. 2014 2LT RS
Today after reading some more here I removed the VTC and back to original. Now we go from bad to worse.
these are the codes
P16A0 ?
P0113-intake air temp sensor high voltage
P0102 Mass air flow sensor low frequency
P00F4 ?
P0097 IAT sensor 2 circuit low bank 1
P2127 Acc pedal position sensor 2 low voltage
P2122 Acc pedal position sensor 1 low voltage
I now have the reduced power, CEL, rough idle with or without VTC connected.
what I have done.
-disconnected throttle body connecter and checked wires are secure
-gave the Mass air flow sensor a wipe with clean micro cloth
-removed butterfly assemble and wiped. operated freely but wondered why it was not fully closed.
-pulled fuses for ecm & tcm
Now it is all back together and the battery is disconnected for overnight
any suggestions?
|
Clear the codes to eliminate any the VTC may have caused and are leftover. If you get any again you'll know what to focus on.