Quote:
Originally Posted by 1Canuck
battery connected with no VTC, ignition ON engine OFF, codes
P16A0 ?
acc pedal D 19.6%
acc pedal E 9.8%
command TAC 22.4
P0174 system too lean bank 2
P0102 Mass or volume airflow circuit low input
P2535 Ignition 1 Switch Circuit High Voltage (PCM)
clear codes successful but they return immediately
start engine, clear codes and they return over and over
dash readout service stabiltrak & reduced engine power also come back after code clear.
Install VTC and same as above all over no difference.
removing VTC to avoid warranty hassle and taking to dealer
|
VTC setup was done each time
pedal position physical 0% VTC voltage 0.5
pedal position physical 100% VTC voltage 2.1
It is this voltage 2.1 each of the last 4 times
I thought was 5 not 2.1 @ 100%