There is a DYI for the NON Positive Displacement Blower Cars.
Thought I would share the results of putting one over a Whipple .
Also haven't seen anyone who added the stripes on the vent.
Even Moving the vent back a few inches wasn't enough to clear the Body and Throttle body area.
The area under the second and third Hex section has approx. 1/2 to 3/4 inch of material being ground off.
Moving the Hole in the Hood forward by an inch may have reduced the amount of mesh being ground for clearance, but I had to start somewhere .
There is no way any usable amount of the rain drain was going to fit,
so I added an aluminum closeout panel to improve the looks.
Haven't finished yet but needed a break so decided to post current progress.
