Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

felixbed · 08-28-2009, 07:33 PM

Got my DT shorty headers in and I am trying to develop a plan to put them in. I need to disconnect the O2 sensor but I cannot for the life of me figure out how to get that clip open up there between the firewall and the engine. Haven't looked at the rear sensors yet. I can barely get a hand down there let alone try to pop the retaining clip out. Do you pop that harness off the block or does this require some special talent or tool that I do not have? Just don't want to break something and have a dead ss in the driveway. This didn't seem as though it was supposed to be difficult but that clip has it in for me.
Thanks for any tips.

08-28-2009, 07:33 PM	#1
felixbed Drives: 2010 victory red ss Join Date: Nov 2008 Location: new jersey Posts: 19	Header installation Got my DT shorty headers in and I am trying to develop a plan to put them in. I need to disconnect the O2 sensor but I cannot for the life of me figure out how to get that clip open up there between the firewall and the engine. Haven't looked at the rear sensors yet. I can barely get a hand down there let alone try to pop the retaining clip out. Do you pop that harness off the block or does this require some special talent or tool that I do not have? Just don't want to break something and have a dead ss in the driveway. This didn't seem as though it was supposed to be difficult but that clip has it in for me. Thanks for any tips.