I just found this thread and first have to Thank Mach and all of the folks that have contributed to this thread. It's Very interesting!
I've reread this thread twice and saw it asked once, but not answered.
I understand that the best way to cut them open is by using a new, sharp utility or razor knife or exacto knife to keep the cut lines thin, but once the housing is open and the led's are installed and fastened, how did you seal them back up to prevent condensation and leakage?
I'd probably either superglue them together or use 2 part epoxy (the kind that is used for building R/C cars) and then use some paintable silicone caulk that I'd smooth out, to waterproof them.
That's just a guess though!
Thanks in advance!
