Quote:
Originally Posted by christianchevell
The bearing surface looks like crapola too.... new block $1200.... the lifter bore....bore it sleeve it, then you also have to pull and reinstall the bearings and drill out the sleeve that was put in.... weigh the costs to reassemble with new bearings and if you trust it... and yes you might get 100$..lol for the bare block, as you know blocks can only be over honed to .020 max as the sleeves in the block are cast in and you are most likely due for new rings and a fresh hone .005 at least so it adds up with 80k on the odometer.
|
Yea the cam got ****ed up too...I bought 4.070 wiesco 15cc gas ported pistons and bearing new rings and rods callies.I just want to do this shit once...Where can I get block for 1200? Cheapest I ve seen was 1400...