Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

marsmann · 02-20-2016, 11:52 PM

Good thread. Lots of great ideas and alternatives. Here are some pics I had taken but had not posted of my install. I used the ACS 4teen heat extractor kit. I wanted the water tray. But I made some modifications since I felt it is a bit restrictive. Granted the air pressures inside the engine bay and outside, along with relative flow, create a suction where the heat is drawn out but I thought I would better assist it by drilling holes on the back side for more suction.

Cut hood, cut the underhood area to prepare for tray, drilled out tray, installed.

02-20-2016, 11:52 PM	#762
marsmann Drives: 2012 2SS/RS Vert M6 Join Date: Jun 2014 Location: South East, PA Posts: 117	Good thread. Lots of great ideas and alternatives. Here are some pics I had taken but had not posted of my install. I used the ACS 4teen heat extractor kit. I wanted the water tray. But I made some modifications since I felt it is a bit restrictive. Granted the air pressures inside the engine bay and outside, along with relative flow, create a suction where the heat is drawn out but I thought I would better assist it by drilling holes on the back side for more suction. Cut hood, cut the underhood area to prepare for tray, drilled out tray, installed.