Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - IT LIVES! My Z/LE ZL1 + 1LE + 2SS = Z/LE ;o) LSA SC [COTW 2/09/15]

hammdo · 02-26-2016, 08:09 PM

Well, just got back. GPI and Ryan were awesome!

So, Ryan made the scaling adjustments to the stock ZL1 IAT2 settings. Car ran fantastic! We tested the current tune with my new updates. Driveshaft was smooth on the Dyno. Now, I did not expect to see any increase in RWHP from the Driveshaft and Turn One power steering upgrade, and I didn't. RWHP was exactly the same, but the delivery was smooth. Ryan noticed how little to no vibration he felt doing the pulls. Car sounded strong! So all set on the IAT2 updates.

Torco was a non starter. The engine did not want it and we could not adjust the timing enough to make a difference. I did mix it, so it could have been that but I'm not going to push it. The engine is happy where it's at.

Nice drive there and back. Awesome service from Ryan, James, and GPI .

So, that is about it for this setup. It's running so good, I'm not going to change much. I do have the analog IAT for the Aero Force so that is next...

Anyone need 5 gallons of Torco ;o)?

-Don

02-26-2016, 08:09 PM	#583
hammdo 'It's an experiment' Drives: [COTW 2/09/15] '11 GPI LSA SC Z/LE Join Date: May 2014 Location: Dallas TX Posts: 8,709 View My Garage	Well, just got back. GPI and Ryan were awesome! So, Ryan made the scaling adjustments to the stock ZL1 IAT2 settings. Car ran fantastic! We tested the current tune with my new updates. Driveshaft was smooth on the Dyno. Now, I did not expect to see any increase in RWHP from the Driveshaft and Turn One power steering upgrade, and I didn't. RWHP was exactly the same, but the delivery was smooth. Ryan noticed how little to no vibration he felt doing the pulls. Car sounded strong! So all set on the IAT2 updates. Torco was a non starter. The engine did not want it and we could not adjust the timing enough to make a difference. I did mix it, so it could have been that but I'm not going to push it. The engine is happy where it's at. Nice drive there and back. Awesome service from Ryan, James, and GPI . So, that is about it for this setup. It's running so good, I'm not going to change much. I do have the analog IAT for the Aero Force so that is next... Anyone need 5 gallons of Torco ;o)? -Don __________________ 747 RWHP 794 RWTQ "Horsepower sells cars, torque wins races." - Enzo Ferrari See My Build: http://www.camaro5.com/forums/showthread.php?t=385577 Last edited by hammdo; 02-28-2016 at 05:43 PM.