Quote:
Originally Posted by QmaroSS
Will Stainless Works Retro Chambered cat back (part#: CA11CB) mate up to Stainless Works 1 7/8 headers and high flow cats (part #: CA11HDRCATST)?
CA11CB says it connects to factory but not to the SW headers. The first post in this thread shows these two part numbers together. I would like to get the Retro Chambered Cat Back to start and at a later date upgrade to the SW headers. Will they work together?
|
Talked to sw today. Your headers will come with connectors (2.5-3")coming out of the cats. its 3" down to 2.5 into the cat back and 3" the rest of the way back. Thats the only way that it will work and have no fabricating. I dont see going from 2.5 to 3" for a few inches will hurt anything.