sorry all for the delay
Chozn:
here is a video of how mine looks at night. you have to cut/cover one of the wires in the bulb for the low tail light. I taped mine off so it is reversible if i really wanted it
dmp: the
oracle video makes it look super easy and neat, it really isnt the hardest thing in the world. it is just time consuming and plastic shavings fly everywhere. if you cut slowly and take your time, youll be fine. dont pry the lens off while cutting. there are parts that are thicker that you have to cut through. if you try to pry off the lens and didnt cut all the way through, you risk breaking something. you can check if your cuts are good by running an exacto knife in the cut to find any bits of plastic that still needs cutting. if there was something that i would have done differently, it's to mask off the lens before starting to prevent any scratching and to save a few minutes cleaning silicone off the front of the lens.
Chaotic: i got them from
ebay . any 160mm led ring will do. you can buy 2 rings and cut/solder them as shown, or buy 4 rings and use the halves that have wires attached.
Chozn: I used little strips of 3M double sided tape to mount the rings.