Quote:
Originally Posted by JDBeck23
Apparently Steve is under the impression that the OP hooked in AFTER the amp... since both sets of wires are very close to one another... Im guessing. Just a third party point of view here. If you hooked in before the amp, then you did it right, and should have nice clean base.
|
I am. In the pic below you can see the loc is wired to green and blue wires and are twisted. The only wires that are green and blue and twisted are the ones coming out of the amp at the the power plug. Those are the ones powering the 6x9s. Anyone can trace those and hook up a loc to them. Whereas the input wires (ie before the amp straight from the HU) are mostly tans and browns. There's on blue, but no green. Finding these takes more work, but my kit explains which ones they are and which wires on the loc to hook to each. I know you will get cleaner bass using the pre-amp singal than a post-amp signal. The factory BA amp looks like a piece of crap, so I would not want to amplify any signal coming out of it and feed to to my speakers. Just my .02
