Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - Hesster's 2010 SS "Street Monster" Build Thread

hesster · 04-15-2016, 07:26 PM

Front Suspension assembly is done.
Finished up the rears today, assembled the brakes, and installed the Rear Sway Bar. So I searched the forum to determine if the sway bar should be installed with the end link with the 3 positions angled up, or down, as it has a slight offset from dead straight. I installed the Bar with the end link pointing up, as I saw one pic om the C5 forum and hope it is correct. [B]The Sway Bar Links are a pain to install, and they seem angled, but followed the instructions. Anyone let me know if this installation looks correct.

Last bit of work today was to saw off a 24" section of my exhaust at the crossover so I can install a resonator, as the car is ungodly loud after the blower and cam along with the Borla Atak - this was a PITA, and I have more work to do to separate the exhaust.

04-15-2016, 07:26 PM	#23
hesster Drives: '10 T/A Conv, '10 2SS, '77 SE T/A Join Date: Dec 2015 Location: Michigan Posts: 887 View My Garage	Front Suspension assembly is done. Finished up the rears today, assembled the brakes, and installed the Rear Sway Bar. So I searched the forum to determine if the sway bar should be installed with the end link with the 3 positions angled up, or down, as it has a slight offset from dead straight. I installed the Bar with the end link pointing up, as I saw one pic om the C5 forum and hope it is correct. [B]The Sway Bar Links are a pain to install, and they seem angled, but followed the instructions. Anyone let me know if this installation looks correct. Last bit of work today was to saw off a 24" section of my exhaust at the crossover so I can install a resonator, as the car is ungodly loud after the blower and cam along with the Borla Atak - this was a PITA, and I have more work to do to separate the exhaust. Attached Images Last edited by hesster; 08-07-2017 at 09:55 AM.