Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - HUGE problem with warped rear bumper fascia!!!

KFH · 09-13-2009, 04:21 PM

Hey, I had the same thing on my car. The problem is that it was not assembled correct. Jack up the car, remove the wheel, then remove the three screws and one bolt in the wheel well. Pull the bumper away from the wheel well far enough to see the tabs. One or two of the tabs are not seated properly, they need to be bent back forward to line up, and then the bumper just pops right into place. I had to fix both sides, left side had one tab bent, the right had two.

09-13-2009, 04:21 PM	#9
KFH 1SS Victory Red Manual Drives: 2010 1SS 6 Speed Manual Join Date: Apr 2009 Location: Oakville, ON, Canada Posts: 215	Rear Bumber Bulge Fix Hey, I had the same thing on my car. The problem is that it was not assembled correct. Jack up the car, remove the wheel, then remove the three screws and one bolt in the wheel well. Pull the bumper away from the wheel well far enough to see the tabs. One or two of the tabs are not seated properly, they need to be bent back forward to line up, and then the bumper just pops right into place. I had to fix both sides, left side had one tab bent, the right had two. __________________ 1st Camaro - 77 Type LT Rally Sport, 3 Speed Manual, Inline 6 2nd - 94 Z28, 6 Speed Manual LT1 V8 3rd - 2010 1LT, 6 Speed Manual LLT V6 4th - 2010 1SS, 6 Speed Manual LS3 V8, RX Catch Can, Holley iNTECH CAI, Flowmaster Force II Exhaust