Quote:
Originally Posted by FNG
Here's a ton of info about the kit; including how to update the firmware and program the SWC:
http://www.tampabaycamaros.com/pac-a...4101-hands-on/
here's how Beat6162 and I have our steering wheel controls setup with the Kenwood DDX9903S:
I even put some info in there about disabling OnStar using the PAC software
 |
Hallo, FNG,
i have read your great write up about this kit. Wow, so many information. I have had the PAC-UP and have updated the firmware. Then i have reprogramed my SWC functions for Germany without OnStar. Thank you very much. Now i can answer to a call and i can end a call with SWC. I will give the link of your website to the german camaro drivers.
I have bought a StarTechcom 61cm Intern 5 pin USB IDC Motherboard Header Kabel F/F and have exchanged the pins at this cable, so i have connected this cable to the interface, the other end i can reach in the glove compartment. So i can update the interface at any time. Thank you very much.
best regards from Germany
Egbert Gertz
__________________
Chevrolet Camaro - V8 - MT - 2013 - European Version - Inferno Orange/ Inferno orange - ACC Sidemarker ghosted - Dash Kit PAC RPK5-GM4101 with DNX8170DABS - Amp KAC-8406 - Sub Pioneer TS-WX110A - Rear- and Front-Camera - ACC Mail Slot Scanner RGB - Pedders Sportsryder - painted parts in engine compartment - black powder coated original rims - H & R wheel plates 20mm front and rear axle - 1 LE steering wheel - MGW Short shifter replacement - aluminum door Pins - ACS T4 Splitter - us-mirrors - ZL1 side rockers - High Wing Spoiler