Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post

Splat · 01-20-2017, 04:31 PM

Will the flares fit.... yes, but because they were meant for the 2014-15 Z/28, it will look unfinished.

Same goes for the side skirts, witch you will need.

And same goes for the rear.

My plan is this. Buy the flares and rockers, depending on the front end, go with a 2014 Z/28 ( This wont be cheap because you will need headlights, wiring harness, and the Z/28 Front lip) so it will be a plug and play, or ZL1 or even a 1LE lip.... buy a cheap 3D printer and build your own custom end caps to blend the bottom flare to the lip of the car.

This goes with the rear, I was going to start this project sometime later this year.

01-20-2017, 04:31 PM	#2
Splat Drives: 2012 1SS M6 IOM Join Date: Dec 2012 Location: New Rochelle New York Posts: 1,428 View My Garage	Will the flares fit.... yes, but because they were meant for the 2014-15 Z/28, it will look unfinished. Same goes for the side skirts, witch you will need. And same goes for the rear. My plan is this. Buy the flares and rockers, depending on the front end, go with a 2014 Z/28 ( This wont be cheap because you will need headlights, wiring harness, and the Z/28 Front lip) so it will be a plug and play, or ZL1 or even a 1LE lip.... buy a cheap 3D printer and build your own custom end caps to blend the bottom flare to the lip of the car. This goes with the rear, I was going to start this project sometime later this year. __________________ 2012 1SS Camaro LS3 Inferno Orange Mods: LSA Supercharger, 2.55 Pulley, Custom Boost Cam, ARH LTH 1 7/8, HFC, 3' Magnaflow Exhaust, JLT CAI, Elite CC V2, BO White Stage 2 TB, GM 3.91 Gears, DSS CF Driveshaft, BMR Bushing Kit.... . Tuned by JTM Motorsports 540 Hp 550Tq on 9PSI Axles, Monster Clutch, Hotchkis TVS Track Pack kit.......For 2018.