|
I just purchased the Lingenfelter axle back which is built by Corsa, it's a good looking and well built system but both companies are a joke. They did not include any instructions as to where to make the cut and it is nearly impossible to accurately gauge where to make the cuts with the huge stock mufflers in place and all the compound angles and bends. I'm not an idiot and the guy who helped me with the install is the head tech at an Acura dealership, built a low 9 second Evo and does great fabricating work and even he says it was very difficult to figure out. He ended up make three cuts(actually 6) to make sure he didn't chop off too much. In his words, "simply because of the lack of instructions it's the worst system he has ever installed" and to quote him "he has seen sh!t from China with crappy Chinese instructions that were easier to install". I called Lingenfelter yesterday and they pawned me off to Corsa. I then spent 35 minutes on the phone with a Corsa tech rep who was a nice enough guy but could not answer my questions or tell me where to make the cut.
....bottom line stay away form Corsa and Lingenfelter systems unless you want to mortgage 4 hours of your day on a job that should take 45 minutes or worse yet end up paying a shop for the install and them have to charge you 4x what it should cost because their techs run in to the same problem as I did.
__________________
Richard Partlow
|