02-07-2017, 11:28 PM
|
#18813
|
Drives: 2012 IBM 2SS/RS LS3/M6
Join Date: Apr 2015
Location: Atlanta, GA
Posts: 354
|
Quote:
Originally Posted by Jazzzed
No it has 3M double sided tape on the underside, and it is extremely tacky. I made sure it was lined up correctly before getting it anywhere close to the chassis because I didn't think I'd be able to pull it off if it was crooked. At least not without damaging something. It won't go anywhere once it is installed. I did wipe down the inner door surface with alcohol pads first to make sure it was clean. Got that tip from a video on youtube. They also fit fine under the door. There are no clearance issues with the plate. However, I do see that one of the rubber grommets on the bottom of the door is touching the plate. Not enough to impede the door or scour the plate or anything, but I do see an imprint on it. Haven't decided what to do about that yet.
|
Thanks for the info! I'm gonna have to get these and give them a try. They look good in the pics, especially for $50.
__________________
Stainless Power LT Headers, K&N Typhoon CAI, VMAX Ported Throttle Body, Jannetty Tune, Phastek Scoop & Washer Bottle Relocator, VTC
Resonator Delete w/Flowmaster Super 10's, BMR Lowering Springs, Koni Orange Struts, Factory Hurst Short Throw Shifter, Skip Shift Eliminator, DRL & Halo Harness, Window Valet
Scosche Kit w/Pioneer AVH-4100NEX, Lloyds Custom Mats, Blue LED Footwell Lighting
|
|
|