[hammdo]

Continuing on the MSD setup, I mounted it in the trunk here:



I used 2 screws and velcro (just to hold it in place while I drilled the holes). I also used rubber hose to keep the unit from rattling:



Routed the wires and the hose this way:





I then took off the rear fuse box (WHAT a pain to get off, especially if you're 'round') and located the fuse and the 'right' red/white wire to splice into:





I'll cut the 'right' red/white wire and then solder in the connector! I'll then add the 'inline' 30 amp fuse for the 'battery' side, and finally, get the vacuum line ran to the front!

-Don