Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - IT LIVES! My Z/LE ZL1 + 1LE + 2SS = Z/LE ;o) LSA SC [COTW 2/09/15]

hammdo · 10-14-2017, 06:14 PM

OK, this is a bit of a long one, so I'll break each up into their own sections

Coil Harness

ABS/StabiliTrak

VVT Delete

This is the coil harness.

One of the harness came in today -- big difference. Wire length is longer and, you had to pay attention to how the harness is installed - remember, these are on the 'back' of a coil bracket, so, looking @ this:

Now arranged:

You can see how much longer the new ones are and, the connector differences.

NOTE:

We need to setup the harness backwards (I believe these are directional). so, when I removed the harness cover, I flipped the harness and now #2 connector is to the right -- I then 'dotted' them so I know which one went where.

Here is the part #:

Routed the coil harness where the previous one was -- worked perfect and, lot more wire to route correctly. This did solve the 'miss' @ idle but, did not solve the StabiliTrak/ABS error. Also, the % of Alcohol has not blipped yet, -- have to wait until the ABS is taken care of..

-Don

10-14-2017, 06:14 PM	#1663
hammdo 'It's an experiment' Drives: [COTW 2/09/15] '11 GPI LSA SC Z/LE Join Date: May 2014 Location: Dallas TX Posts: 8,709 View My Garage	Coil Harness OK, this is a bit of a long one, so I'll break each up into their own sections Coil Harness ABS/StabiliTrak VVT Delete This is the coil harness. One of the harness came in today -- big difference. Wire length is longer and, you had to pay attention to how the harness is installed - remember, these are on the 'back' of a coil bracket, so, looking @ this: Now arranged: You can see how much longer the new ones are and, the connector differences. NOTE: We need to setup the harness backwards (I believe these are directional). so, when I removed the harness cover, I flipped the harness and now #2 connector is to the right -- I then 'dotted' them so I know which one went where. Here is the part #: Routed the coil harness where the previous one was -- worked perfect and, lot more wire to route correctly. This did solve the 'miss' @ idle but, did not solve the StabiliTrak/ABS error. Also, the % of Alcohol has not blipped yet, -- have to wait until the ABS is taken care of.. -Don __________________ 747 RWHP 794 RWTQ "Horsepower sells cars, torque wins races." - Enzo Ferrari See My Build: http://www.camaro5.com/forums/showthread.php?t=385577 Last edited by hammdo; 10-26-2017 at 09:35 PM.