Quote:
Originally Posted by olblue75
Do you have pics of inner spacers and sizes??
|
The way it spaced out I used a "thick" and "thin" washer on each side. I made a change from the original plan......... in order to support (hold in place) the hard rubber inserts, the large diameter washer was placed against the bushing and the smaller OD washer (the thin one) was placed next to the subframe bracket. The smaller OD is the same as the OD of the aluminum bushing insert. I used the smaller OD washer because I did not have a large OD that was the correct thickness. I then tacked the two washers together to make them a single unit.
I get with my alignment guy this evening.