Anyone have installation input on the Moreno Camber Plates? I am using BC Coilovers, and not sure about what is required to use off the stock Strut isolator, if anything. It seems they are saying to pry it apart to use part of it. Not finding anything much in the Forums or Google.
The instructions state:
10. Remove spring isolator (yellow/orange for 2012+, black for 2010-11) from strut mount. A flat prying tool may be necessary.
11. Install spring Isolator to camber/caster plate. Silicone band wrapped around spring perch acts as an adapter for the factory spring isolator. Install isolator to spring perch with band. It is a tight fit, use light oil to lubricate silicone if necessary. The best method for installing the spring isolator is to pull the silicone band down to where it is partially installed to the perch, this way the band will not fold while installing the spring isolator. *If you are using aftermarket coilovers with 2.5" springs, do not install spring isolator, and remove the silicone bands from spring perch. The perch will sit directly on the spring.*
Don't want to mess anything up, and get it right the 1st time.