[Joe M 2012 2SS]

You don't flip clay to the unused side after using one side, you fold the clay to make two fresh sides, and make it into a patty again. Clay will last much longer this way.

I only use traditional clay when doing a car with very soft paint, which excludes 5th and 6th gen factory paint on Camaro's.

The SM Speedy prep towel (fine grade) does the claying job in about 1/3rd of the time, requires no pressure to use, if dropped on the ground can be rinsed in warm water for a minute, will release every particle on it, and can be used on the paint again with no chance of damage. No kneading required. Fold it in 1/4th's, rinse with warm water after all 4 sides are used. It lasts for 90-100 uses. Traditional clay is obsolete.

Compounding is only needed one time, and by using proper wash technique, is never needed again.

I don't use traditional finishing polish anymore. Carpro Essence does the job in less than 1/2 the time, with outstanding results.

After you polish it's imperative to remove any residue or oils left on the clear coat. Use IPA or Carpro Eraser. Whatever product you are using for protection will bond properly when this is done. No bare hands in this step, wear gloves to keep oils from your hands off the clear coat.

An SI02 sealant will outlast any polymer sealant, and provide much better protection against acidic things (bird bombs and bug splatter) that get on the clear coat. I like Carpro Reload. Wash the car with Carpro Hydrofoam or Adams Wash/Coat every 2-3 months to top off protection.

The Microfiber Madness Crazy Pile is hands down the best towel ever made for wax/sealant excess removal. No towel even comes close to it.

Glaze is a waste of time. One drive in the rain and it's gone. One day in the sunlight when it's above 80* and it's gone. Use it for going to a car show only.