Your write up for the DIY is spot on. I see you have a 2SS. I took the CAI tube off then the drive belt off then cut the A/C belt off. Went to put the stretch belt tool on and it keep hitting something behind the pully wheel.
So I got my 4 books 1,000 pages of manual for these 5thh Camaros. Started reading the next step just to find out. I have the RPO L99 so it is necessary to loosen and reposition or remove the camshaft position sensor/actuator wire harness bracket for belt installation. This just made it a big pain in the rear. Took me a little over an hour.
And I used a 15/16 deep socket 1/2 drive it fit the tightest. Better than a 25mm or 1 in. socket.
|