View Single Post
Old 12-29-2013, 08:54 AM   #10
randy's2012
 
randy's2012's Avatar
 
Drives: 2SS/RS, supercharged LS3
Join Date: Jun 2013
Location: Hamilton Twp. New Jersey
Posts: 89
Just got done last week installing the solid cradle bushings on my 2012 SS. I did like the guys on here said about just the rear frame down one side at a time. It took some work to get the back ones out due to the guide that is part of the frame and goes inside the rear cradle bushing itself. That steel guide that is part of the frame sticks down another 3 inches which made it harder to work the old one out and to get the new one in. But was able to do it no problem just take some time. Changed all four in less then 4 hours from start to finish without removing exhaust or dropping the frame out of the car. Also replaced the springs all the way around at the same time dropping the car 1" (at least I think it is only 1"). Got a 4 wheel alignment and am ready for spring time to roll around.
randy's2012 is offline   Reply With Quote