View Single Post
Old 10-24-2013, 11:29 AM   #9

911medic's Avatar
Drives: 2012 SIM 2LT/1970 Camaro
Join Date: Nov 2012
Location: Near Minneapolis, MN
Posts: 1,578
Originally Posted by BZapp725 View Post
Thanks for the post. So youre saying my 2013 lt will always show what gear its in if i have it in M? When i used tapshift before it wasnt but i guess it was in drive then...
It shows in your DIC/HUD if you use the paddles. Just moving the shifter to M puts it in Sport Mode (S in the DIC/HUD) until you touch a paddle.

Using the paddles will show the gear no matter if in D or M, but if in D it goes back to showing D after a few seconds (10 maybe?), whereas if in M it will continue to show the gear after you use the paddles once.
All bleeding stops eventually -- 2012 2LT Auto w/sunroof -- My journal thread
Roto-Fab Intake & W/W Relocate Kit -- ADM Race Scoop -- Dynomax VT Axle-Back Exhaust -- Vitesse Throttle Controller
RX Catch Can -- Drake Bowtie Delete -- JacFab Radio Face Cover -- LED Fog Lights -- LED Dome/Trunk/Plate Lights -- Gen5DIY Dash ABL -- Diode Dynamics Cupholder Lighting
Wishlist: ACS T5 Splitter -- Hood Vent Mod -- Footwell/Door Pull/Homelink Button Lighting
911medic is offline   Reply With Quote