Quote:
Originally Posted by jeremywes
I'm suprised that you got 315's on a 20x10. Discount tire said they would only reccomend 305's. I thought I read some where that you could machine the wheels but that might just be urban myth. Try the same post in the wheel and tire forum and you might get some better ideas than mine.
|
u/bestwheeldeals on here sells almost all of his wheel packages in a 20x10 with 315 variant, and I recall a thread where someone called him out and he pretty strongly stood behind it. Modica Brothers had no negative input on the subject. I did a good bit of research, seems the Nitto Invos run a little slim, and the results I see on the ground is very little to no noticable sidewall bulge.
Anyway thanks for the response. I believe my ground contact is very adequate, just concerned about the fenders rubbing the tires after I lower it. Hopefully someone here has run 315s on a similar offset with the Pfadt stage 2 kit, without issue...