So I just had the Eibach E10-23-018-01-22 Pro-Kit installed on my SS, and of course after dropping the car you need an alignment. However it looks like the Alignment shop that I went to, may have used the wrong setup. From what I understand the Gen 6 SS uses FE3 and they did an alignment based on the V6 FE2. (note: I know very little about what I'm talking about
)
My question is, does this matter? To me it looks like my camber is kinda crazy. The left rear is basically maxed at -1.8. I think I'm going back after work today, to have them re-do it.