Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - View Single Post - Full Camaro Ultimate Factories Video: From Sheet Metal to End of the Line

montreal2010yellow · 12-25-2011, 08:13 PM

Featured on Camaro5 HOMEPAGE

This is Holidays time, so take a look at the 45 minutes video of the full, I mean full, assembly of our favorite car. ENJOY...

Sorry if it's a repost, but I have'nt seen any post of this video from months and months. You will all see what goes in and all the engeering required to build your car. Again Enjoy. 45 minutes video.

WATCH VIDEO @ http://www.camaro5.com/full-camaro-u...nd-of-the-line

Name: Screen Shot 2011-12-26 at 9.55.14 AM.jpg
Views: 4116
Size: 44.9 KB

Here are some interesting tidbits :

Each Camaro takes 18 hours of assembly time
There are 734 robots doing the nearly 5,000 spot welds needed to create the body shell for each Camaro Coupe.
In order to get to the paint shop the Camaro body has to be transported on a bridge over a city street where it is painted and then shipped back across the bridge to the trim area for final detailing.
One Camaro rolls off the assembly line approximately every minute.
The Camaro engine is produced at a different plant and has to be shipped approximately 2 hours to the assembly line where it finally meets the Camaro.

12-25-2011, 08:13 PM	#1
montreal2010yellow Drives: 2 LT/RS YELLOW, AUTO., VIN NO. 602 Join Date: May 2010 Location: LAVAL (10 min. north of Montreal), CANADA Posts: 3,526 View My Garage	Full Camaro Ultimate Factories Video: From Sheet Metal to End of the Line Featured on Camaro5 HOMEPAGE This is Holidays time, so take a look at the 45 minutes video of the full, I mean full, assembly of our favorite car. ENJOY... Sorry if it's a repost, but I have'nt seen any post of this video from months and months. You will all see what goes in and all the engeering required to build your car. Again Enjoy. 45 minutes video. WATCH VIDEO @ http://www.camaro5.com/full-camaro-u...nd-of-the-line Here are some interesting tidbits : Each Camaro takes 18 hours of assembly time There are 734 robots doing the nearly 5,000 spot welds needed to create the body shell for each Camaro Coupe. In order to get to the paint shop the Camaro body has to be transported on a bridge over a city street where it is painted and then shipped back across the bridge to the trim area for final detailing. One Camaro rolls off the assembly line approximately every minute. The Camaro engine is produced at a different plant and has to be shipped approximately 2 hours to the assembly line where it finally meets the Camaro. __________________ T2 Facia, ACS TL1 Hood, ACS Winglets. G5CR CAI. Hotchsic Strut Brace and more...