View Single Post
Old 07-03-2010, 07:45 AM   #16
gearhead440's Avatar
Drives: Yellow 2SS, 6 speed manual
Join Date: Jan 2010
Location: Concord, NC
Posts: 218
I worked for several hours to incorrectly remove the pulley to discover that there are indentions on the back side of the hub. Once I used these indentions and a push rod that was long enough, the stock pulley came right off. There is a "seal" that is on the lip of the stock pulley but does not fit on the TSP replacement pulley that I installed, nor is it required.
Attached Images
gearhead440 is offline   Reply With Quote