Well I decided to change my alignment up a little bit today. Unfortunately I did not get the factory settings for the front as we decided to loosen the front suspension to get max camber prior to starting.
I have completed 4 autox events in the car so far and will be running next week at the Tire Rack National Tour in F-Street. After 4 events I am tearing up the outside front and even rear of my tires so some changes were definitely overdue. This is what we came up:
Alignment was done with 3/4 tank and myself in the drivers seat in an otherwise empty car.
Front Camber:
Left: -1.7 degrees
Right -1.9 degrees
Front Toe:
Left: -.05 inches
Right: -.05 inches
Total: -.10 inches
Front Caster: This is were I am a little concerned as it is not adjustable
Left: 4.9 degrees
Right: 6.0 degrees
Not sure why these are so far apart. Any ideas?
Steer Ahead: 0.00
Rear Camber:
Left: -1.2 degrees
Right: -1.2 degrees
Rear Toe:
Left: .04 inches
Right: .04 inches
Total: .08
Thrust Angle: 0.00
My Factory rear settings were -.8 camber on each side. 0.00 toe left and 0.05 toe right with a thurst angle of -0.05
This is on a factory stock car. Any ideas why my caster is so off?